Warmup Dual Overlay For Underfloor Heating System

Creating innovative products for adding convenience in homes and offices, as far as underfloor heating is concerned, has been the forte of Warm Up. It provides a smooth and seamlessly finished subfloor for soft covering such as carpet, vinyl, and linoleum. Its low heat resistance enables easy passage of heat through the floor finish for even distribution throughout the room. Extremely thin with only 7mm depth, it is easy to install in combination with an insulated underlay.

• Very thin at only 7mm in depth
• Installation Manual PDF provided in the technical tab
• Features:
• Easy to cut and shape around fixtures with a knife or saw
• It consists of a baseboard [3mm] and a topboard [4mm] with a contact adhesive to bond them together. Very thin at only 7mm in depth
• Protects the heating element from damage if the flooring is not laid immediately
• Provides even heat distribution
• Technical Specification:
• Size: 1200mm x 600mm
• Thickness: Top board 4mm, Baseboard 3mm, total thickness: 7mm, Tolerance: +/- 0.2mm/7mm
• Composition: MDF, fitted with an interactive adhesive
• Density: 770 [kg/m³]
• Bending strength: >40 kg/cm²
• Humidity: 4-10%
• Thermal Rm Value: 0.047 [m².K.W.-1]
• Fire Class, DIN4102: B2

Please Note: The Warmup dual overlay is not suitable for wet areas. The heating MUST NOT exceed 27°C and should always be controlled via a floor sensor thermostat. The maximum Tog rating for the carpet, underlay and the Warmup Dual Overlay should not exceed 2.5 Tog. The heating system MUST be switched off before installation. If the floor finish is to be glued the underfloor heating system must not be switched back on until the glue has completely set. Temperatures should then be increased gradually.