Tre Mercati Little Venice Bridge Kitchen Sink Mixer Tap

Josy Asked :

Hi, my worktops are 30mm, will the Tre Mercati Venice bridge kitchen sink mixer tap fit?

Answered By QS Team

Tre Mercati product code 294 – Little Venice Bridge sink mixer is compatible with timber worktops of 30mm as it can be countersunk. Extensions would need to be ordered to be used on granite or quartz. Code: MIS049 – 90mm extensions to suit Bridge sink mixers – this can be purchased from any local retailer near you.

Was this answer helpful?

1 1

Jen Asked :

Hi, The tap collars appear to be stuck due to limes cake which means I cannot gain access to the cartridge or even the nut before the cartridge. Have you any advice as to the best method to open this/what tool to use? Thanks

Answered By QS Team

We can only suggest that you pour boiling hot water over the chrome rings and then use rubber to grip and unscrew the handles.

Was this answer helpful?

1 1

simon Asked :

looking to buy In pewter. But also wanted a single tap to match for a separate "filtered water" tap next to this main bridge tap - do have any recommendations?

Answered By QS Team

Tre Mercati doesn’t supply a filtered water tap in pewter. Are you looking to purchase a pewter tap and provide your own carbon filter to make the water filtered?

Was this answer helpful?

1 1

Simon Asked :

Re the tap below - are the tap centres adjustable IE will the tab fit into existing tap holes?

Answered By QS Team

Little Venice bridge sink mixer in CP has adjustable centres from 120mm to 230mm.

Was this answer helpful?

3 1

Steve Asked :

Hi, Interested in the Tre Mercati Little Venice bridge tap. Could you please tell me what the pipe hole sizes required are and what spacing, Thanks.

Answered By QS Team

The pip hole sizes are 25mm. The leg spacing size is 120-230mm as they are adjustable.

Was this answer helpful?

1 1

Phil Asked :

You say the thread is 60mm - what is the maximum thickness of worktop that these will fit? Is it connected to the water supply using a standard tap connector?

Answered By QS Team

There isn't really any maximum thickness as if your worktop is saying 70mm thick then it would be standard to crevice out under the worktop for the connections. However, I believe that the tail length is 40mm, not 60mm. Apologies if someone has said this. As standard, we would say that the maximum would be 30mm for all the connections; however, you can always hollow out the underside of a thicker worktop to make these fit.

Was this answer helpful?

1 1

Stuart Asked :

Could you please tell me the hole spacing required to the legs pointing straight back and the threads' length?

Answered By QS Team

Hi the hole centres when on the back will be 90mm

Was this answer helpful?

1 1