Clearwater Zuben L Dual Flow Kitchen Sink Mixer Tap

Susan Asked :

Is this tap complete with the filter starter set to install under the sink? I think the initial filter lasts 6 months. Do you also sell replacement filters?

Answered By QS Team

The product is supplied with everything required to fit and use the tap with filtered water. It uses a Clearwater Sinks & Taps filter - Pure P6C1.

Was this answer helpful?

1 0

Renata Asked :

Hi, How is the filter installed - do you have any photographs? Also, how long does the filter last, where can I buy replacements and how much is the filter?

Answered By QS Team

Please refer to the installation instruction PDF file provided in the product's Additional Info section for the filter installation. Filters last up to 6 – 12 months, depending on use.

Was this answer helpful?

Bobby Asked :

Hi, what is the total height of this tap my window opens inwards, and there is only a clearance of 245mm between the sink and the window when it opens inwards.

Answered By QS Team

The total height is 265mm.

Was this answer helpful?

1 0

Denny Asked :

CLEARWATER ZUBEN ZU2SS. 1) Is this tap WRAS approved? 2) What is the length(s) of flexible tails? 3) What are the connection sizes of the tails, 15mm, 1/2-inch, and 3/8-inch?

Answered By QS Team

The tap is not WRAS approved. The flexi tail length is 600mm. Connection sizes of the tails - 1/2-inch.

Was this answer helpful?

David Asked :

Hi, could you confirm the operation of the hot/cold lever- is it pulled out for flow and then from a vertical position just pulled toward you for hot or did it also push backwards? I have no room to push backwards.

Answered By QS Team

Cold start and forwards for hot. The handle moves back around 1cm, so clearance needs to be 2.5 cm from the rear of the tap hole.

Was this answer helpful?

1 0